The Hotplate framework is constructed in stainless steel and incorporates insulation and removeable side panels. The side panels are insulated so as to achieve minimal heat loss thus giving the product the maximum heat available.
The Hotplate Plattens are manufactured in carbon steel and are 8 to 10mm thick, dependant upon the plant width.
The plattens, dependant upon the plant width, are designed so as to be turned over when the initial surface becomes built up with debris and therefore the Platten life is extended prior to cleaning.
The Plattens have, as standard, automatic air tensioning.
The heat source is by Gas Fired Ribbon Burners.
Flame ignition is automatic as are both the Temperature Control and Heat Sensing.
The Burner construction is modular, incorporates a Flame failure system and complies with Gas Safety Standards.
The product is fed on to the Hotplate Plattens from the feed source, viz: Volumetric Depositor and approximately 66% in to the Bake Time the product is turned over in a two stage operation using Servo Driven individual Spatulas.
Product removal from the Hotplate is also achieved by the utilisation of Servo Driven individual Spatulas which have a two stage motion, the product is turned over at this point, returning the top face to the top face position. The product is then placed on to a Cooling Conveyor Belt.
Also included, as standard is an Exhaust Canopy complete with fans and regulation pressure switches
